Cap01 users located are:
USA Canada England Turkey France Germany Poland Slovenia Romania Latvia Iran U.A.E. India Korea Malaysia Indonesia Thailand Philipines South Africa Serbia Bulgaria Hungary Morocco Algeria Tunusia Brazil Chile Argentina Netherland Australia
Sept, 08, 2011
Yes I have been using it! Wrote my own HAL for EMC2 with digital out of CAP04.
I am cutting 6500mm/min, 1.5mm (+/-0.5mm) cutting height, no clamping of material.
I am really happy now it is working, no regrets, just a little disappointed with the wire loom.
I have even recommend it to someone else this is his response.....
"Thanks for the good advice, ……….
I will be ordering the Agelkom thc this week
thanks for all the help!
I didn't mention the wire loom!
Thankyou for your great service
This week we installed the height controller and it is
working perfect, I will order soon a second height controller.
See also pictures, many thanks.
Best regards, from the Netherlands
October 5, 2009
I have installed the torch height controller.
Your documentation is very precise and covers all the problems, thank you very much
for an excellent product.
July 1, 2009
Dear Mr. Gucdemir,
The height sensor arrived on Monday. I've already made some "dry" tests
on my bench and it seems to perform very well. ……………
It even improves resolution because for short distances sensitivity is
higher. I also tested the behaviour when only part of the sensor ring area
is covered by the sheet and it also performs better than expected.
……………... I have to say that I'm quite impressed by the quality of your product.
CNC- und Steuerungstechnik, Elektronikentwicklung
July 1, 2009
June 10, 2009
June 6, 2009
Kelpe Technical FZC